The steel pipe modulates the rust removing and brushing machine. It's fast and efficient. Only 2 people can clean up the mortar and rusty steel pipes. The paint is automatically painted. The speed of 12 meters per minute can be completed. Straightening and rust removing. The flexible rust removing device has the characteristics of high quality, high efficiency, convenient operation and maintenance, and durable material. It only erasure the surface and the rust of the steel pipe without damaging the steel pipe and the original paint. Positive and negative double brush 360 degree completely remove cement. Rust. Super clean. Every hour can be cleaned up by straightening paint steel pipe 360 meters, pipe through the collective temperature to 50 degrees, in the paint system enhances the durability of steel paint, clean up the successful resolution of the problem of building steel tube. The elastic paint brushing device has the advantages of convenient installation, convenient operation and maintenance, durable paint brush. The paint is uniform, and the thickness is random. The paint will not fall to the ground with the steel tube, and there is only a little paint at the pipe. The advantages of no splash, waste, uniform paint layer and no dripping are implemented. It has solved the shortcomings of other models using artificial spray paint and inhomogeneous and inefficient brush paint. After the work, the remaining lacquer to release the oil valve to recover the oil barrel, cleaning the tank is very simple. 30 pounds of oil paint standard 300 steel tubes (artificial, paint and turpentine were 7 cents a 6 meter tube). The paint brush can be replaced by more than 300 tons of steel pipe. Save labor cost and improve work efficiency.
The technical parameters of the steel pipe straightening and rust removing and painting machine:
Adaptive range 48 steel pipe
1 meters 20 degrees bend straightening
Straightening length is not limited
Motor power 3kw4kw
Rotational ratio of reducer 31:5
Voltage 380V
Steel pipe straightening and rust removing brush paint machine attention:
The entrance method of the elbow
1. to the top of the curved top, this method is the best way to enter the tube.
2. to the top down, the secondary method is the secondary entry method.
Attention: when the entrance of the pipe, do not take the wrong way to place the pipe in the right and left side.
3. straight tube refurbishment, spray paint and bend pipe straightening do not go on in the same period.
4., we must first renovate all the straight pipes, and then straighten them up. Because the pressure of the upper wheel is much larger than that of the straightened pipes, so they cannot be separated from each other in the same condition.
When the 5. bend is straightened, the upper pressure wheel regulates the handle, and the refurbishment of the straight tube needs to be loosely adjusted.
